Nieuw project Hulp nodig?
  • PROJECT STATUS
  • PERIODE
  • BADGE
Laatste reacties
TonGiesberts
TonGiesberts 6 uur geleden
RF Power Meter (mother board) -bare PCB (160193-2)https://www.elektor.com/rf-power-meter-mother-board-bare-pcb-160193-2   RF Power Meter (RF front-end board) - module (160193-91)https://www.elektor.com/rf-power-meter-rf-front-end-board-module   or instead of the front-end module RF Power Meter (RF front-end board) - bare PCBhttps://www.elektor.com/rf-power-meter-rf-front-end-board-bare-pcb   and all part as listed in the BOM in the article RF Power Meter For measurements up to 10 GHzhttps://www.elektormagazine.com/magazine/elektor-201803/41378 Here the software needed for the Arduino Nano can be downloaded. You have to program the Arduino Nano yourself!  
RF Power Meter with seperate RF break-out-board [160193]
TonGiesberts
TonGiesberts 7 uur geleden
The maximum input offset of a TL062CP is 15 mV. That's high and maybe the cause different builds of the bat detector using the same components show different sensitivity. This high offset makes the TL062 C not suitable for use as a comparator. The signal from IC3A has first to equalize the offset before tripping the output of IC3B, thus making it less sensitive when the hysteresis set with P2 is very small or 0. A contemporary low power/low bias current/low offset opamp would be preferable for IC3.  
Bat detector with amplitude recovery
Thomas Bunge
Thomas Bunge 19 uur geleden
New forms and header files.
HV Power supply with tube and semiconductor curve tracer
Rainer Schuster
Rainer Schuster 21 uur geleden
Hello Thomas, yes  - you can adjust the voltage with R17 (R5 for current calibration). And yes: It would be nice if you could send me your forms for the higher resolution display. Thanks in advance  
HV Power supply with tube and semiconductor curve tracer
HaSch
HaSch 21 uur geleden
Yes, I recompiled. But it has to work without recompiling because TRIG1 is one of the 2 you use for 2 US sensors.
Back ultrasound radar for bike: